First time house owner here, I have some notions of electronics, but never dealt with HVAC before. I have the following setup. Carrier heater connected to a DuroDyne DuroZone SMZ-2SW. No AC, just this heater. There are two zones setup and a damper for each one. Iím guessing that the heater itself is acting as the fan for both zones. I installed Nests everywhere before I had a chance to learn about the whole common wire fiasco, and of course I do not have common wires. I have done a bit of research but nothing matches my situation specifically and I donít want to break something.

The master zone goes to a bedroom and thereís 3 wires connected: R, G, W. Surprisingly the master zone has worked pretty well so far both summer and winter, although Iíve heard that a Nest as a master thermostat is not a good idea.

The other zone goes to a room and has only R & W connected. G is floating (because thereís only one fan I guess?). After working well throughout the summer while heating was off, the Nest now keeps running out of battery. I am guessing itís because it canít do power stealing between R and W as the heating is on and thereís no G wire, because the other one works well with 3 wires.

So I looked at the spreadsheet for the SMZ-2SW and thereís no dedicate slot for a common wire. However I see many points where I could tap some 24V AC that the Nest could use to charge.

So here are my questions:
1. Can I connect the C terminal of the Nest in zone 2 to the Terminal 1 of zone 2 on the board? The spec says 24vac common. If not, why?
2. Do I need an Add-a-wire system instead? What does it do exactly?
3. If I need to change the board to get one thatís supports common wires, which one would you recommend and why?
4. Why do people say here and there that itís a bad idea to have a next as master thermostat?

Hereís a link to the spec for the SMZ-2SW: http://www.durodyne.com/durozone/SMZ-SWLR.pdf

Here are a few pictures of the wiring on the board:
Click image for larger version. 

Name:	Wiring1.jpg 
Views:	38 
Size:	91.8 KB 
ID:	1811
Click image for larger version. 

Name:	Wiring2.jpg 
Views:	46 
Size:	95.4 KB 
ID:	1812

Thanks a lot for your help!